Custom Built SCR Chargers

The MPower SCR Battery Charger range are constant voltage systems designed to supply mission critical loads, and maintain battery banks in a fully charged and ready condition.

APPLICATIONS
Built around proven SCR technology, these chargers have wide application in a range of installations and a strong track record in extreme environments.

SCR Battery Chargers may be used to:
* charge lead acid batteries of any technology, including Gel and AGM types and keep them fully charged.
* charge Nickel Cadmium batteries (plate and fibre technology types).
* recharge battery systems after discharge and also provide power for the standing load and;
* provide short-duration high power outputs for switch tripping applications and still provide power for the standing load.
SCR Battery Chargers can be used in emergency lighting systems, standby power for critical loads, communications, switch tripping, engine-start systems, petrochemical and mining installations.

ENCLOSURES
The standard charger comes in an 1P21 housing, powder coated "APO Grey" in a stand alone floor mount enclosure. Systems can be designed to accommodate the battery banks within the charger enclosure or a separate compartment. Wall mount options and various degrees of "IP" rating are available on request.
Various colour finishes are also available.

Standard Specifications (Others available on request)
lnput voltage:	24OVAC,415VAC+1-10% Others available on request	lnput frequency:	50/60HZ;tranSient43Hz-66Hz
Output Voltage:		Ripple voltage:	Not more than 1% of nominal system voltage with battery connected Additional filters can be added to reduce rms ripple to less than l% of nominal system voltage with battery connected
Nominal:	12V, 24V, 3OV, 48V, 11OV & 22OV Others available on request	Temperature Range:	0 C - 50 C ambient Higher range operation permissible by derating output
Float:	As above + 15% for lead acid+15% for Nickel Cadmium	Alarms:	Alarms may be optioned to either latching with manual reset or non-latching
Boost:	As above + 20% for lead acid, +35-40% for Nickel Cadmium	Standard:	Charger Fail
Ripple current:	Typically not more than 5% of mean current	Options:	Mains Fail, Charger Fail, High Volts Low Volts, Earth Fault, Low Electrolyte, Circuit Breaker Tripped, LVD Operated and Battery Reversed Polarity.
Cooling:	Natural convection.  Forced ventilation available	Standards:	MPower chargers are designed to comply with AS3000 and AS4044
Efficiency:	Typically 78% 95% depending on conditions(95% is at full load)

MPower SCR Charger PDF